Publicité
Les langues disponibles
Les langues disponibles
Putting into operation
Symbol
No
action
for
10 seconds
Opening
door
and
closing it again
Note: Illustrations of the display are shown in the English
version.
3.2 Menus
The appliance functions can be found in various menus.
Menu
Description
Main menu
When you switch the appliance on, you are
automatically in the main menu.
From here you can navigate to the most
important
Settings menu and to the Advanced menu.
The Settings menu contains additional
appliance functions for setting up your
appliance.
(see 3.2.1 Opening the Settings menu)
Settings
menu
Advanced
The advanced menu contains special appli‐
menu
ance functions for setting up your appli‐
ance. Access to the Advanced menu is
protected by the numerical code 1 5 1.
(see 3.2.2 Opening the Advanced menu)
3.2.1 Opening the Settings menu
Fig. 2 Example illustration
u Carry out action steps according to the illustration.
w Settings menu is open.
u If necessary: Navigate to the desired function.
3.2.2 Opening the Advanced menu
Fig. 3
82
Description
"Open Advanced menu" symbol:
Navigates to the Advanced menu
and opens the advanced menu.
If necessary: Navigate to the
desired function in the Advanced
menu.
(see 3.2.2 Opening the Advanced
menu)
If you do not perform any action
on the display for 10 seconds,
the display either jumps back to
the higher-level menu or directly
to the status display.
If you open the door and immedi‐
ately close it again, the display
jumps directly back to the status
display.
appliance
functions,
to
Fig. 4 Example illustration, access with numerical code 151
u Carry out action steps according to the illustration.
w The expanded menu is open.
u If necessary: Navigate to the desired function.
3.3 Sleep mode
If you do not touch the display for 1 minute, the display
switches to sleep mode. In sleep mode, the display bright‐
ness is dimmed.
3.3.1 Ending sleep mode
u Press any navigation key.
w Sleep mode is ended.
the
4 Putting into operation
4.1 Switching on appliance (first use)
Make sure that the following requirements are fulfilled:
The appliance is properly installed and connected
q
according to the installation instructions.
All adhesive strips, adhesive and protective films and
q
transport locks are removed from inside and on the appli‐
ance.
All marketing leaflets are removed from the drawers.
q
You are familiar with the functionality of the Touch
q
display. (see 3 Functionality of the Touch display)
Switch on the appliance using the Touch display:
u If the display is in sleep mode: Briefly touch the display.
u Carry out action steps according to the illustration.
Fig. 5 Example illustration
w The status display appears.
w The appliance cools to the temperature set at the factory.
w The appliance starts in demo mode (status display with
DEMO appears): If the appliance starts in demo mode,
you can deactivate demo mode within the next 5 minutes.
(see Demo mode)
* Depending on model and options
Publicité
