Publicité
Les langues disponibles
Les langues disponibles
Controls
Temperature
Use this function to set the temperature.
The temperature depends on the following factors:
-
Frequency of door opening
Duration of door opening
-
-
Room temperature of the installation site
-
Type, temperature and quantity of food
Temperature zone
Factory-set
temperature
5 °C
Fridge section
0 °C
ColdFresh
Setting the temperature in the fridge section
Fig. 10 Example illustration
u Carry out action steps according to the illustration.
w Temperature is set.
Setting the temperature in ColdFresh
Set the temperature using the ColdFresh-Value. (see Cold‐
Fresh-Value )
Temperature unit
Use this function to set the temperature unit. You can set
degrees Celsius or degrees Fahrenheit as the temperature
unit.
Setting the temperature unit
Fig. 11
86
Recommended
setting
4 °C
u Carry out action steps according to the illustration.
w The temperature unit is set.
B-Value (see
Cold‐
Fresh-Value )
Use this function to set the ColdFresh-Value. With the Cold‐
Fresh-Value, you can set ColdFresh slightly warmer or colder
if necessary due to higher or lower ambient temperatures.
The ColdFresh-Value is pre-set to value 5 as delivered. If you
change the ColdFresh-Value, refer to the following table:
Value Description
1
1-4
5
9
Setting the ColdFresh-Value
u Carry out action steps according to the illustration.
w The ColdFresh-Value is set.
Use this function to set the FreezerLevel. You can use the
FreezerLevel to make the **** freezer compartment slightly
warmer or colder. The FreezerLevel is pre-set to value 5 as
delivered.
Value Description
1 to 4 **** freezer compartment gets colder.
5
Fig. 12 Example illustration: Switch from degrees Celsius to
degrees Fahrenheit.
ColdFresh-Value
Lowest temperature
The temperature can drop below 0 °C which means
foods can easily freeze.
Pre-set temperature
Highest temperature
Fig. 13
Fig. 14 Example illustration: Switch from value 5 to value 6.
FreezerLevel*
Pre-set value
* Depending on model and options
Publicité
