Performing Measurements; Distance Measurement - TOOLCRAFT LDM 80T Mode D'emploi

9. Performing measurements

• In order to conduct a measurement, the target laser (A) must be
activated.
• If the target laser is deactivated, briefly press the MEAS button (D)
to activate it. No measurement will be conducted.
With the target laser being activated, press the MEAS button to
•
conduct a measurement.
• After each distance measurement, the laser will be deactivated and
must be activated again for the next measurement.
• In order to delete the last measured reading during a measurement,
press the I button (F).

10. Distance measurement

1. Point the laser at a right angle at the target and hold the device as
still as possible.
2. Press the MEAS button (D). Shortly, a beep sounds and the reading
is shown on the display. The display will also show the memory
slot (4).
3. Proceed as described above in order to conduct further
measurements. The previously measured reading will be moved to
the line above.
48