TOOLCRAFT LDM 80T Mode D'emploi page 52

If you have set a stake-out point (see chapter "Settings
menu"), a plus or minus symbol will appear left from the
reading.
If the plus symbol is displayed, you must move forward
to reach the next stake-out point.
If the minus symbol is displayed, you must move
backwards to reach the next stake-out point.
Once you have reached the stake-out point, the product
will emit several long beep sounds.
If, for example, you have set a stake-out point of 1 m, the
long beeps will sound at a distance of 1 m, 2 m, 3 m, etc.
4. If needed, press the MEAS button to pause the continuous
measurement. The measurement values remain visible.
5. Press the MEAS button to continue the continuous measurement.
6. Push the I button (F) to end continuous measurement. The reading
measured last remains visible.
52