TOOLCRAFT LDM 80T Mode D'emploi page 65

3. Use the + (K) and – (E) buttons to set the desired value. Press and
hold the respective button for fast selection mode.
4. Use the MEAS button (D) to switch between pre-decimal place and
decimal place.
5. To reset the value to zero, press the I button (F).
6. Press the settings button to confirm your settings.
7. Press the I button to switch to standby mode.
Target laser
1. Press and hold the settings button (H) for approx. 2 seconds.
2. Briefly press the settings button three times. The following is
displayed:
3. Use the + (K) or – (E) button to turn the target laser on or off.
65