Stihl iMOW 6.0 EVO Notice D'emploi page 66

English
► Feed the perimeter wire through until it pro‐
trudes upward for a = 37 cm (length:
®
1x iMOW Ruler).
► Using the appropriate cable marker (11), mark
the beginning of the wire (9) near the housing.
Marking will facilitate the subsequent connec‐
tion to the correct terminal.
7.4 Positioning the docking station
within the mowing area
1
2
► Install the perimeter wire (1) in the base plate
so that the guide wire lies flat in the cable duct
and is secured by the hook (2).
4
► Attach the perimeter wire (1) directly on the
base plate (3) with a fixing pin (4).
If the docking station is against a wall:
66
9
11
1
3
7 Positioning the docking station
3
► Route the perimeter wire (1) 37 cm (length:
®
1x iMOW Ruler) away from the base plate (3)
toward the side.
► Route the perimeter wire (1) in parallel to the
base plate (3) toward the edge of the mowing
area and maintain a distance from the wall of
37 cm (length: 1x iMOW
► Route the perimeter wire (1) clockwise around
the mowing area,
If the docking station is in an adjacent, navigable
area:
1
3
► Route the perimeter wire (1) 37 cm (length:
®
1x iMOW Ruler) away from the base plate (3)
toward the side.
► Route the perimeter wire (1) in parallel to the
base plate (3) toward the edge of the mowing
area.
► Route the perimeter wire (1) clockwise around
the mowing area,
If the docking station is partly positioned in a bed
and partly in the mowing area:
► Route the perimeter wire (1) away from the
base plate (3) toward the side and maintain a
distance of 37 cm (length: 1x iMOW
parallel to the bed.
1
®
Ruler).
8.
8.
1
3
®
Ruler) in
0458-012-9601-A