Stihl iMOW 6.0 EVO Notice D'emploi page 62

English
► As a result of its design, the robot mower
leaves a strip with unmown lawn along unnavi‐
gable areas. This strip can be used, for exam‐
ple, to sow flower seeds and create areas with
blossoming vegetation for insects.
► If you want to mow without leaving an edge
along inaccessible areas: Install edging stones
or flagstones with a minimum width of
a = 24 cm along these areas.
6.2 Preparing the robotic mower for
operation
► Remove the packaging material and transport
locks.
► Ensure that the following components are in a
safe condition:
– Robotic mower,
– Mowing unit,
– Battery, 4.6.3
– Docking station and power supply,
► Positioning the docking station,
► Installing the perimeter wire,
► Completing the perimeter wire installation,
9.1
► Installing the guide wire,
► Electrically connecting the docking station,
11.1
► Charging the robot mower,
► Locking the Bluetooth
► If you cannot carry out these steps: Do not use
the robotic mower and contact a STIHL
authorized dealer.
62
a
4.6.1
4.6.2
7
8
10.1
12.1
®
radio interface,
7 Positioning the docking
station
7.1 General requirements
► Choose the docking station location so that
the following conditions are met:
– The charging cable (1) can be installed out‐
side of the mowing area to connect to a suit‐
able wall socket.
– The docking station and power supply are
positioned in a clearly visible area.
– The docking station is in the mowing area
that is the largest or most frequently
mowed.
– If possible, protect the location against
adverse weather conditions and direct sun‐
light.
– If possible, the docking station is within
range of a wireless network (WLAN connec‐
tion).
– If possible, in a mowing area with a slope,
the docking station is in the lower area of
the slope.
4.6.4
13.1
7 Positioning the docking station
Wi-fi
1
0458-012-9601-A