"Boost" Button - Crosswave ED-3.2 EX Mode D'emploi

Figure 19 – Instrument Display
Boost Mode +/–
The currently selected mode is displayed at the top of the panel.
Remaining battery capacity and remaining range are displayed
at the bottom of the panel. You can switch between battery
capacity and current remaining range by pressing both mode
change buttons at the same time.
Lights on the bicycle are turned on and off by pressing the light
button.
Light Ein/Aus
Recommended Mode of Operation
After switching the system on, select the operating mode and
set the ED-3.2 EX Pedelec in motion by pedalling. On gentle
slopes, it is helpful to push the Pedelec slightly forward using
the feet so that the motor does not have to develop the propulsive
power from nil. Otherwise, the Pedelec uses a high amount of
power and cannot develop much drive at speeds between 0 –
3 km/h.
In the interests of operational distance, you should pedal as
much as possible under all driving conditions since the
operational distance lies well below the system's capabilities
when using mainly motor power.
The activated mode 1 limits the maximum operational power
level and saves the capacity of the battery. You will only notice
the reduced assistance when going uphill and during acceleration.

"Boost" Button

with the "Boost" button, you have the option of using starting
or pushing assistance. The bicycle accelerates to 6 km/h without
pedalling. Furthermore,you can use a "Boost" function. If you
operate the button, the assistance is switched into the highest
level for a short time. You then have the full drive performance
available should an unexpected situation occur. By releasing
the button, the ED-3SP returns to the previous operating mode.
GB
97