Start-Up; Start Up Of Drive Battery - Crosswave ED-3.2 EX Mode D'emploi

Start-up of the CROSSWAVE Pedelec
The following chapters of the user manual of the CROSSWAVE
Pedelec presume that all basic ergonomic settings and necessary
safety checks of your bike have already been done:
– Handle bar and seat have been brought to the desired position
and tightened appropriately.
– The wheels have sufficient tyre pressure and their axle nuts
have been tightened too.
– The function of the brakes and pedal drive has been checked.
– The lighting system is functioning.
For more information refer to the Chapter
"Adjustments before ride".
86
Start-up of the drive battery:
Now take the drive battery out of the holder in the luggage
carrier of the CROSSWAVE Pedelec. Remove any protective foils
– especially the ones on the electrical contacts located at the
lower end.
Now check the charging state of the battery
by pressing the key on the LED-charging status
display. If less than two LEDs or no LED lights
up, the battery may be damaged. In this case
please contact your dealer.
Ship Mode
When delivered, the battery is located in the "delivery mode",the
internal electronics is completely off and the battery does not
deliver power.
This mode does not protect against deep discharge, so the
battery should taken after about 3 months in operation, and
should be charged.
To activate the battery leave it IN the recording (MUST be
made contact with the controller). If the charger is connected
for about 30 seconds, the electronics fully powered and ready
to use.