Front Wheel Luggage Carrier; Rear Wheel Luggage Carrier; Maintenance Instructions; Maintenance Of The Pedelec Drive - Crosswave ED-3.2 EX Mode D'emploi

– Use only tested trailer couplings and fix them at the
prescribed positions.
– Use only trailers that correspond to the latest safety technology.
– First try out the trailer without load.
– Follow the StVZO (Road Traffic Licensing Regulations)
requirements for the lighting equipment of the trailer.
– No liability for damages on account of trailer usage!
Front wheel luggage carrier, basket
– Follow the manufacturer specifications on the components
for loading.
– Avoid overloading!
– Do not transport any living animals!

Rear wheel luggage carrier

– Observe the manufacturer specifications on the
components for loading.
– Use the standard transportation bags, baskets and
clamping devices.
– Do not transport any persons or living animals.
102

Maintenance instructions

To enjoy the comfort of the numerous functions for a long time
to come, the CROSSWAVE Pedelec should be maintained just
like a normal cycle. Besides, to guarantee riding safety, regular
checks must be performed on the brake, the tyre pressure, the
different screw joints, especially handle bar, seat and axle nuts
without fail.

Maintenance of the Pedelec drive:

When maintaining the auxiliary electrical drive system, ensure
through appropriate handling the maximum capacity of the
drive battery and protection of the other electrical components
against prolonged wet conditions.
As far as possible, the Lithium-ion battery should be recharged
only after complete discharge. Please try to avoid immediate
re-charging of a nearly full battery after a short ride.
In winter or during longer periods of non-use, the battery should
be recharged at the latest after 3 months. Only this way you
can ensure a long product life. If you do not use the battery
over longer periods, take the battery out of the Pedelec so that
no standby current in the electronic circuit is unnecessary
consumed.
After a ride in rain or if a lot of mud gets deposited on the
housing components, the dirt must be wiped away as thoroughly
as possible with a wet sponge. Let the CROSSWAVE Pedelec dry
afterwards.