Charging The Drive Battery - Crosswave ED-3.2 EX Mode D'emploi

The battery should now be firmly positioned in the support slot
as demonstrated in Graphic 3. The push cylinder lock should be
cleanly locked into the battery housing.
88
Locking the battery ensures that it is firmly held so that damage
caused through vibration is prevented; thereby guaranteeing
that optimal electrical contact is maintained between the battery
and the electronics of the Pedelec.
Figure 3
The CROSSWAVE Pedelec
is now ready to go!
Figure 4
Charging and care of the battery
The ED-3.2 EX Pedelec operates with a 37V 8.8Ah lithium-ion
battery. PanTerra™ uses top-quality cells which are combined
into a 37V cell pack. In addition, the battery also contains an
electronic protection system which prevents deep discharging
and overcharging.
Avoid storing a completely empty battery over several weeks.
Always use the high-quality lithium-ion charger supplied (Graphic
6) or the corresponding original PanTerra™ replacement part
for charging your battery. The original charger operates using
The key can be removed in the locked position!
PanTerra™ recommends that the key is always
removed!
This ensures that neither can the lock
accidently open by itself with the battery
falling out nor can the key be lost.