Barbecook SPRING 300 CREME Mode D'emploi page 8

6.3.1 C A
OUPLING
You need a 19 mm spanner and a cross-slotted screwdriver.
Screw the coupling on the gas tube of the appliance (A) and
1
tighten it with a 19 mm spanner (B).
A
Slide the hose over the coupling (C) and tighten the
2
clamping ring with a cross-slotted screwdriver (D).
C
6.3.2 C B
OUPLING
You need a 22 mm spanner and an adjustable spanner.
Screw the coupling on the gas tube of the appliance (A) and
1
tighten it with a 22 mm spanner (B).
A
8
A B
B
D
B
www.barbecook.com
Screw the gas hose on the coupling (C) and tighten it with
2
two spanners. Hold the coupling with a 22 mm spanner,
while turning the hose with an adjustable spanner (D).
C
6.4 Connecting the hose and cylinder to
the regulator
Depending on the type of pressure regulator you use, you need a
cross-slotted screwdriver and/or an adjustable spanner.
Connect the hose to the pressure regulator. Do one of the
1
following:
If the hose has a clamping ring, slide the hose over the
•
regulator and tighten the clamping ring with a
cross-slotted screwdriver (A).
If the hose has a nut, screw the hose on the regulator and
•
tighten the nut with an adjustable spanner (B).
A
Connect the pressure regulator to the gas cylinder. Do one of
2
the following:
If the regulator has a nut, screw the regulator clockwise
•
on the cylinder and tighten the nut with an adjustable
spanner (C).
If the regulator has a screw thread, screw the regulator
•
counter-clockwise on the cylinder (D).
C
6.5 Replacing the cylinder
Close the gas supply and set all control knobs to OFF.
1
Disconnect the empty cylinder and connect the full cylinder.
2
Check the cylinder, the hose and all gas connections for
3
leaks. See "7 Checking for gas leaks".
D
B
D