Barbecook SPRING 300 CREME Mode D'emploi page 14

Below the exploded view of your appliance (second part of the
manual), you find a list with all parts of which the appliance is
composed. This list includes a symbol that specifies the material
of each part, so you can use it to check how you have to maintain
a particular part. The parts list uses the following symbols:
Symbol
Enamel
Chrome
Stainless steel
Powder coated
11.5 Storing the appliance
If you do not use your appliance for a longer period of time, store
it in a dry place. Before you store the appliance:
Disconnect the gas cylinder. Never store your appliance
•
indoors (not even in a garage or shed) as long as it is
connected to the gas cylinder.
Clean the burners and the grills, rub them with oil and wrap
•
them in paper.
Cover your appliance with a Barbecook cover. Register your
•
appliance at www.barbecook.com
you need.
11.6 Storing gas cylinders
These instructions apply to both empty and full gas cylinders.
Always store gas cylinders outdoors, in a well-ventilated
•
area. Make sure they are not exposed to excessive heat or
direct sunlight.
Never store a gas cylinder in an area that can become very
•
hot (in a car, on a boat...).
Never store your gas cylinder or spare gas cylinder in the
•
cabinet of your appliance.
Never store your spare gas cylinder near a gas appliance in
•
use.
Always store gas cylinders outside the reach of children.
•
Always store and transport gas cylinders in upright position.
•
11.7 Ordering spare parts
Parts that are directly exposed to fire or intense heat have to be
replaced from time to time. To order a spare part:
Look up the reference number of the part you need. You find
1
a list of all reference numbers below the exploded views in
the second part of this manual and on www.barbecook.com.
If you registered your appliance online, you will
2
automatically be guided to the correct list.
Order the spare part at your point of sale. You can order
2
parts both under and outside warranty.
14
Material
to find out which cover
www.barbecook.com
12 WARRANTY
12.1 Covered
Your appliance comes with a warranty of two years, starting from
the date of purchase. This warranty covers all manufacturing
defects, provided that:
You used, assembled and maintained your appliance
•
according to the instructions in this manual. Damages
caused by misuse, incorrect assembly or inadequate
maintenance are not regarded as manufacturing defects.
You can present the receipt and the unique serial number of
•
your appliance. This serial number starts with a G, followed
by 15 digits. You can find it:
On this manual and on the starter pack that included the
-
manual.
On the packaging of the appliance.
-
On the inside of the bottom front panel.
-
The Barbecook quality department confirms that the parts
•
are defective and that they proved defective under normal
use, correct assembly and adequate maintenance.
If one of the above conditions is not met, you cannot claim any
form of contribution. In all cases, the warranty is limited to the
repair or replacement of the defective part(s).
12.2 Not covered
The following damages and defects are not covered by the
warranty:
Normal wear and tear (rusting, distortion, discolouration...) of
•
parts that are directly exposed to fire or intense heat. It is
normal to replace these parts from time to time.
Visual irregularities that are inherent to the manufacturing
•
process. These irregularities are not regarded as
manufacturing defects.
All damages caused by inadequate maintenance, incorrect
•
storage, improper assembly or modifications made to
pre-assembled parts.
All damages caused by misuse and abuse of the appliance
•
(not using it according to the instructions in this manual,
using it for commercial purposes...).
All consequential damages caused by careless or
•
non-compliant use of the appliance.
Rust or discolouration caused by external influences, the use
•
of aggressive detergents, exposure to chlorine... These
damages are not regarded as manufacturing defects.
13 TECHNICAL SPECIFICATIONS
13.1 Type label
The type label lists all the technical specifications of your
appliance. You can find it:
In the second part of this manual.
•
On the inside of the bottom front panel.
•
13.2 Injector diameters
Main burner: 1,00 mm
•
Side burner: 0,75 mm
•