Bernard Controls SQ Intelli+ Serie Instructions De Mise En Service page 50

22 CREATING OR CHANGING PASSWORD
Select change in the menu turn to OK to confirm.
Select data sheet in the CHANGE menu and turn to OK to confirm.
Select entry code in the DATA SHEET menu and turn to OK to
confirm.
Enter 1st digit with the blue
button, then turn to OK to
confirm.
Enter 2nd digit with the blue button, then turn to OK to confirm.
Enter 3rd digit with the blue button, then turn to OK to confirm.
The new code will not be considered until the user exits the change menu
and confirms the change (change ok?)

Make sure you can remember this code to access the change
menu again.
If you forget your code
Switch off power to the system unit and open the control unity to access the
INTELLI+ board (supporting the display). Move the jumper on the board from
position A to position B, then turn the power back on.
The password has now been reset to zero. Place the
jumper back in its original position (A).
If you leave the jumper in position B, you will still be
able to enter a new password, but it will be reset to zero
the next time you switch the unit on.
English
ENTRY CODE
(0000)
50
jumper