Bernard Controls SQ Intelli+ Serie Instructions De Mise En Service page 16

This icon indicates that the control is proportional (4-20 mA i.e)
0%
and the value of the input signal (setpoint) is indicated in %.
The BUS marker indicates there is a bus communication card.
The marker is followed by a square that shows you the
BUS
communication status (see specific documentation of the
installed bus).
1 and 2 indicate the presence of a redundant communication
card (2 communication channels). The number is followed by a
12
square indicating the status of each communications channel
(see the specific doc. of the installed bus).
11 MENU NAVIGATION
The selector switches used for the electrical control of the actuator is also
used to navigate in the INTELLI+ menus, then to gain access to the settings.
11.1 How to use selectors
Red selector (on the left)
•
Selector on OK: confirm choice
•
selector on OFF: quit the menu
at any time
Blue selector (on the right)
•
Select option
11.2 Accessing Main menu
How to Access the main menu
Set the red selector to local,
Turn the red selector to LOCAL/STOP and hold it; at the same time,
turn the blue selector up and then down.
The main menu is displayed:
MENU
Exit setup
Release the selector, it goes to LOCAL position.
To scroll in the menu options, turn the blue selector up or down.
Menu options appear on the bottom line.
English
16