Installation - Burkert 8025 Notice D'utilisation

3 INSTALLATION

3.2 Installation
Compact version (cf. fig. 3.2)
The compact batch controller type 8025 can
be easily installed into pipes using our
specially designed fitting system.
1.The fitting 4 must be installed into the
pipe according to the installation
specifications in section 3.1.
2.Insert plastic nut 3 into fitting and let
plastic ring 2 snap into guide bush 5.
3.Carefully insert batch controller 8025 1
into fitting. If installed properly, the
transmitter cannot be rotated.
4.Tighten transmitter housing to fitting with
plastic nut 3.
Caution: Plastic nut must only be
!
tightened by hand!
Panel version (cf. fig. 3.3)
For the cut-away of the front panel, follow the instructions on the delivery enclosed film.
For sensor installation, please consult 8020/8030 instruction manual. Install device as
follows:
1. Put gasket 2 on the cover 1 and place the complete unit in the panel cut-away.
2. Screw the spacer bolts 3 on the panel crossing screws 4.
3. Insert the cable clips 10, to hold the different cables (power supply, outputs, sensor)
of the batch controller, into plate 7.
4. Plug connector 5 on socket 6 and fasten plate 7 with screws 9 on bolts 3. Do not
forget the lockwashers 8.
8025-BATCH-**
BATCH CONTROLLER 8025
Fig. 3.2 Installation of batch controller
E-9-