Publicité
Les langues disponibles
Les langues disponibles
a. Press the PTT and Volume Down buttons at the same time while turning the radio on.
b. Wait three seconds before releasing the buttons until you hear "Clone Mode Serial" voice prompt
from the Source radio.
a. Press and release the Volume Down button.
You hear "Wireless" from the Source radio.
2. Turn on the Target radio by performing the following actions:
a. Press the PTT and Volume Down buttons at the same time while turning the radio on.
b. Wait three seconds before releasing the buttons until you hear "Clone Mode Serial" voice prompt
from the Target radio.
NOTE: Avoid putting powered on radios (more than seven radios) in a container together, other
than the Multi-Unit Charger.
3. To start the wireless PROFILE ID Number cloning on the Source Radio, press and release the
Volume Up button.
●
You hear a tone.
●
After cloning is completed, you hear "Pass" indicating cloning is successful or "Fail" indicating
cloning failed voice prompt from the Source radio.
●
On the Target radio, the radio receives the PROFILE ID Number information. You hear "Pass"
indicating cloning is successful or "Fail" indicating cloning failed voice prompt from the Target
radio.
MN001132A01-AE
Chapter 12: Cloning Mode
69
Publicité
