Motorola Solutions DLR1020 Mode D'emploi page 68

MN001132A01-AE
Chapter 12: Cloning Mode
Cloning Mode Status
Switch to Serial Cloning [initiated
by (-) button]
Clone [initiated by (+) button] –
Cloning in progress
Cloning Successful
Cloning Fail
12.5
Troubleshooting Cloning Mode
When and where to use:
The radio audible voice announces "Fail" indicating that the cloning process has failed. In the event that
cloning fails, perform each of the following steps before attempting to start cloning process again.
Procedure:
1. Ensure that the batteries on both radios are fully charged and engaged properly on the radio.
2. Check the cloning cable connection on both Single-Unit Chargers (SUC) and if the cable is switched
to "Cloning".
3. Ensure that there is no debris in the charging tray or on the radio contacts and the radio contact is
touching the SUC or Multi-Unit Charger (MUC) contact firmly.
4. Ensure that the target radio is turned on.
5. Ensure that the source radio is in cloning mode.
6. Ensure that the two radios are both from the same frequency band, same region and have the same
transmission power.
NOTE: The cloning cable is designed to operate only with compatible Motorola Solutions SUC,
PMLN7139_.
Result: When ordering cloning cable kit, ensure to order the cloning cable kit with part number HKKN4028_.
For more information about the accessories, see
12.6
Cloning Mode Using Wireless PROFILE ID Number
The PROFILE ID Number Wireless Cloning feature is useful when you want to clone the PROFILE ID number
for all the radios in your fleet, but you do not want to clone particular radio settings that may be unique
for each radio such as Top button configuration, MIC Gain, Radio Name and others. Wireless PROFILE ID
preserves each user radio setup, but ensure that all radios are under the same PROFILE ID number. This
feature is useful if you do not have a programming Cable, Cloning Cable, or PC easily available.
12.6.1
Configuring Cloning Mode Using Wireless PROFILE ID
Number
Procedure:
1. Turn the Source Radio on by performing the following actions:
68
LED Indicator
Double Blink Red
Solid Red
Not Available
Not Available
Accessories on page
Voice Prompt or Tone
"Serial"
Cloning beeps
"Pass"
"Fail"
76.