Publicité
Les langues disponibles
Les langues disponibles
MN001132A01-AE
Chapter 12: Cloning Mode
Number
12.2.1
Configuring Cloning Mode in Multi-Unit Charger
Prerequisites: Ensure all radios are fully charged.
Procedure:
1. Turn on the target radio.
2. Place the target radio into the Multi-Unit Charger (MUC) target pocket. See
Charger on page 65
3. To turn on the source radio, press PTT and Volume Down buttons simultaneously for three seconds.
You hear Cloning Mode beeps, and your radio announces "Cloning Mode, Serial".
4. Place the source radio into the paired MUC target pocket. See
page 65
for the correct placement.
5. Press the + button.
Your radio announces "Fail" or "Pass".
6. To exit Cloning Mode, long press the PTT button.
NOTE: When ordering MUC, ensure to order MUC with part number PMLN7136_.
12.3
Configuring Cloning Mode Using Radio to Radio
Cloning Cable
Prerequisites:
Ensure all radios are fully charged.
Required devices/tools:
●
Cloning Cable (Part Number HKKN4028_)
●
Two Single-Unit Chargers (SUC)
When and where to use:
66
9
for the correct placement.
Item
Pocket 11
Cloning Mode in Multi-Unit Charger on
Cloning Mode in Multi-Unit
Publicité
