Publicité
Les langues disponibles
Les langues disponibles
Figure 16: Radio to Radio Cloning
Procedure:
1. Turn the radio off.
2. Unplug any cables from the SUC.
3. Plug one side of the cloning cable mini USB connector to the first SUC, and the other end to the
second SUC.
NOTE: During the cloning process, no power is being applied to the SUC. The batteries are not
charged. Only data communication is being established between the two radios.
4. Turn on the Target Radio and place it into one of the SUCs.
5. To turn on the Source Radio, press PTT and Volume Down buttons simultaneously for three seconds.
You hear Cloning Mode beeps, and "Cloning Mode, Serial" voice prompt from your radio.
6. For the Source Radio, power on the radio with the following sequence:
a. Press the PTT and Volume Up buttons at the same time while turning the radio on. Wait three
seconds before releasing the buttons, and you hear "Clone Mode Serial" voice prompt from your
radio.
b. Place the Source Radio in its SUC. Press and release the Volume Up button.
You hear "Pass" or "Fail" voice prompt from your Source radio.
7. To exit the clone mode when the process is completed, press the Power button, or long press the PTT
button.
12.4
Cloning Mode Status Indicator
Press and hold both the PTT button and Volume Down button at the same time, while turning on the radio to
enter cloning mode.
Table 22: Cloning Mode Status Indicator
Cloning Mode Status
Cloning Mode (by default is Seri-
al)
Switch to Wireless Cloning [initi-
ated by (-) button]
LED Indicator
Double Blink Red
Double Blink Red
MN001132A01-AE
Chapter 12: Cloning Mode
Voice Prompt or Tone
"Clone Mode, Serial"
"Wireless"
67
Publicité
