Motorola Solutions DLR1020 Mode D'emploi page 29

For a group of radio to communicate, all the radios need to be on the same channel and have the same radio
PROFILE ID number. The default PROFILE ID number is 0000.
Channel
Current channel that the radio is using, depending on radio model.
PROFILE ID Number
The radio in your fleet, independent of the channels that users are assigned to should use the same
PROFILE ID. Customize the PROFILE ID number to avoid interference from other users using the default
0000 number. To customize your radio fleet PROFILE ID, choose a four digit number and enter it using
the radio Advanced Configuration Mode. Turn off the radio, press PTT → Volume Up → Power buttons
at the same time, and hold until you hear "Programming Mode" voice prompt from your radio. For more
information, refer to the
8.7
Top Button Options
The Top button is programmed to Private Reply feature by default.
You can configure the Top button to other features such as Page All Available, Call Available, Direct Call, and
Mute. You can disable the top button feature.
For more information on Top button configuration, refer to
8.8
Radio Status
Table 10: Radio Status
Radio Status
Power-Up
Power Off
Fatal Error at Pow-
er-up
Channel Busy
Idle Mode
Transmit (Tx)
(standard group
call)
Receive (Rx)
(standard group
call)
Advanced Configuration Mode on page
Front LED Indica- Top Button LED In-
tor dicator
Solid red for two OFF
seconds
Solid red for two OFF
seconds
Double blink red Single blink orange
Not available OFF
Slow blink red OFF
Solid red OFF
Fast blink red OFF
Chapter 8: General Radio Operations
47.
Advanced Configuration Mode on page
Voice Prompt or Tone
"Battery Level <Level>, Channel
<Number>"
Power Off chirps
Not Available
Busy tone
Not Available
Not Available
Not Available
MN001132A01-AE
47.
29