Télécharger Imprimer la page

Stryker 1188HD Mode D'emploi page 22

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 49
Caution
When attaching or removing the coupler, grip only the rear
adapter, as twisting other parts of the coupler may result in
mechanical damage.
Caution
Do not overtighten the coupler, as this may damage the front
window of the camera.
Note
For direct-coupled C-mount scopes (scopes that require no
coupler), thread the endoscope directly into the camera head
until it forms a tight seal.
Caution
Do not overtighten a direct-coupled C-mount scope, as this
may damage the front window of the camera.
2.
Attach an endoscope to the coupler.
• Remove the red dust cap if it is present.
• Push down on the endobody clamp (a) and insert the scope into the
scope end of the coupler (b). (See Figure 6.)
• Release the endobody clamp.
(b)
(c)
Figure 6:
Attaching an endoscope to the camera head via the coupler
3.
Attach a light cable from the light source to the light post on the
endoscope (c) as seen in Figure 6.
Warning
Before each use, check the outer surface of the endoscope to
ensure there are no rough surfaces, sharp edges, or
protrusions.
EN-18
All manuals and user guides at all-guides.com
(a)

Publicité

loading

Ce manuel est également adapté pour:

1188-010-0001188-210-1051188-410-1051188-710-105