Publicité
Les langues disponibles
Les langues disponibles
4 - the sealing strip on the end plate is pulled aside and
the blind plug is removed
5 - the 24V DC wires are disconnected from the termi-
nal block by pulling the plug
6 - the data cable is disconnected from the frequency
converter - shown here on the G120X converter
6 - the data cable is disconnected from the frequency
converter - shown here on the V20 converter
7 - the relief is loosened. The operator panel is un-
hooked from the control, and hung upon the end plate
as shown. Alternatively, hung on a wall or remote
mount, using the two long holes on the backside
8 - the operator panel wires are routed through the slot
in the end plate and the relief is secured. 24V DC wires
and data cable are reconnected and secured with cable
ties. The doors are closed and power is reconnected on
the main switch.
7
Publicité
