Publicité
Les langues disponibles
Les langues disponibles
At full operational speeds with the doors closed the
blower produces noise levels below 80db. It is possible
to make complete installations where the system is
kept at a low noise level provided care is taken to seal
joints, and adequate pipe insulation is used. Contact
Kongskilde for more info.
Accessories
Kongskilde offers the following accessories for the
blowers:
•
Enclosure for outdoor mounting of the operator
panel (MultiAir FC/FCE)
•
Pressure / vacuum or flow control of the blower
performance (MultiAir FC/FCE)
•
Silencer for intake/outlet air
•
External start / stop contact (MultiAir FC/FCE)
•
External motor control (MultiAir FC/FCE)
•
Vibration sensor (standard on all material blow-
ers, and can be purchased as an accessory for
the clean air blowers)
The blower is designed to operate outdoors. Should the
operator panel be repositioned from inside the blower,
the "Enclosure for outdoor mounting" is recommended,
as precipitation and sunlight can damage the panel.
Enclosure for outdoor mounting of the operator
panel (MultiAir FC)
Part no.
Type
123 022 262 Enclosure for outdoor mounting
The operator panel on the MultiAir FC 4000 is mounted
and connected inside the blower on delivery, as shown:
If desired, the operator panel can either be hooked to
the blower end plate, provided the blower is indoors
6
(see below photo), or mounted remotely.
The panel is equipped with 15 meters cable, which can
be extended to max. 150 meters if necessary. Kong-
skilde can supply extension cables in 50, 100 and 150
meter lengths. All extension sets contain data and 24v
supply cores and are suitable for outdoor installation.
Part no.
Type
123 022 311 50 meter extension cable (data + 24V)
123 022 312 100 meter extension cable (data + 24V)
123 022 326 150 meter extension cable (data + 24V)
Use a standard CAT6 data cable and 24V supply cable
for outdoor installation, if necessary. Use cable ferrules
for the 24V cable, and do not extend the cables as
joints may impair reliability.
Mounting of the operator panel to the blowers end
plate, as follows::
1 - the main switch is switched off and locked
2 - the doors on both sides are opened
3 - the cable ties on the operator panel wires are cut
Publicité
