Ambu aBox 2 Mode D'emploi page 20

The IP address assigned by your network can also be found. In the example below, the IP address
is highlighted in a blue box.
7.3. Set up connection to Worklist server
• Enable Worklist
• Enter the required information in Worklist server AE title, Worklist server hostname
and Worklist server port number
• Press the required TLS
Note: If you enable TLS, you need to import the required TLS certificate from a server or
USB flash drive.
•
Choose the modality (ES=endoscopy, US=ultrasound) or enter a specific modality in the
Other field deciding which worklist you choose to retrieve.
34
• Enter the timeframe, that the retrieved worklist will show, in the Display upcoming
procedures (hours)
• Hide past procedures older than (hours)
procedures in the worklist.
• Press Test worklist connection
correctly and the server connection is established.
Import TLS certificate from server or USB flash drive:
You can use TLS for enhanced security when setting up PACS and Worklist server connections.
Enabling TLS requires a TLS certificate to be imported to the displaying unit from a server or
from a USB flash drive. If multiple TLS certificates are imported to the displaying unit,
the PACS/Worklist server will select the required TLS certificate automatically. For import
from server, ensure that the displaying unit is connected to a Wi-Fi or LAN network.
For import from USB flash drive, ensure that USB connection has been enabled for certificate
import and a USB flash drive connected to the displaying unit.
20
with the ON/OFF switched to green.
31
32
33 settings. It is recommended to enable TLS.
field.
35
to verify that the information has been entered
37
33
38
.
36 allows you to limit the amount of
34
37
31
32
35
36