Publicité
EN
NOTICE! Damage hazard
• Do not place the battery charger near heat sources (heaters, direct sunlight, gas ovens, etc.).
• Set up the device in a dry location where it is protected against splashing water.
Safety when connecting the device electrically
DANGER! Electrocution hazard
• For installation on boats: If electrical devices are incorrectly installed on boats, corrosion dam-
age might occur. Have the device installed by a specialist (marine electrician).
• If you are working on electrical systems, ensure that there is somebody close at hand who can help
you in emergencies.
WARNING! Electrocution hazard
• Observe the recommended cable cross-sections.
• Lay the cables so that they cannot be damaged by the doors or the hood. Crushed cables can lead
to serious injury.
NOTICE! Damage hazard
• Use ductwork or cable ducts if it is necessary to lay cables through metal panels or other panels with
sharp edges.
• Do not lay the 230 V mains cable and the 12 V cable in the same duct.
• Do not lay the cable so that it is loose or heavily kinked.
• Fasten the cables securely.
• Do not pull on the cables.
Operating the device safely
DANGER! Electrocution hazard
• Do not touch exposed cables with your bare hands. This applies especially when operating the de-
vice from the AC mains.
• To be able to disconnect the device quickly from the AC power supply, the socket must be close to
the device and be easily accessible.
WARNING! Electrocution hazard
Only use the device in closed, well-ventilated rooms.
CAUTION! Explosion hazard
Do not operate the device under the following conditions:
In salty, wet or damp environments
In the vicinity of corrosive fumes
In the vicinity of combustible materials
In areas where there is a danger of explosions
CAUTION! Electrocution hazard
• Before starting the device, ensure that the power supply line and the plug are dry and the plug is
free from rust or dirt.
8
Publicité
