Publicité
EN
Disconnecting the batteries
Follow the installation procedure in reverse order.
10 Operation
Selecting the house battery type
Before selecting the house battery type ensure the following:
• No batteries are connected to the battery charger.
• The battery charger is connected to an AC power source.
Press the jump starter and house battery type selector button
The LED indicator flashes green and red.
Each press selects the next battery type and the output LED indicator signals the chosen type with the number of
green flashes followed by one red flash:
Number of flashes
1
2
3
4
Using the battery charger
The battery charger automatically charges the batteries when it is connected to an AC source or an alternator.
Charging the starting battery using the house battery
Note The jump start function can only be activated when the battery charger is not connected to an AC
source, no D+ signal is present and the house battery voltage is more than 11.8 V.
Press the jump starter and house battery type selector button (Fig. , 7) for at least 2 s to start charging.
The starting battery is charged for 10 min from the house battery.
Note After 10 min, the process can be repeated by pressing the jump starter and house battery type
selector button (Fig. , 7) again.
11 Cleaning and maintanance
WARNING! Electrocution hazard
Disconnect the batteries before cleaning and maintenance.
NOTICE! Damage hazard
• Never clean the device under running water or in dish water.
18
Description
The lead acid battery type has been selected.
The AGM/lead gel battery type has been selected.
The LiFePo4 battery type has been selected.
The power supply has been selected.
(Fig.
8).
Publicité
