Heidolph Hei-TORQUE Expert Serie Notice D'instructions page 72

Appendix
R0000\r\n R0000\r\nSet\:0\r\n
A direction\r\n
A\r\n
B direction\r\n
A direction\r\n
B\r\n
B direction\r\n
C\r\n Clear Error\r\n
D\r\n Direct control\r\n
N\r\n Null reference\r\n
F\r\n F\r\n
M\r\n M\r\n
t\r\n TMP: xxx\r\n
zSET: xxxx\r\nzACT:
z\r\n
hhmmss\r\n
*RS 232 interface parameters: 9600 baud, no parity, 8 bit, 1 stop bit
Do not send commands in the package, pause between them at least
0.1 s.
The M, F, T and z commands do not function with the RZR overhead
stirrer.
xxxx stands for a one to four-digit number.
\r\n can appear in the answer multiple times consecutively.
Stop stirrer, set speed is retained
Switch on gear stage II
Switch on gear stage I
Delete "overload" error status
Switch off connection:
–
Remote operation is switched off
– The device can again be operated
manually
Set the torque actual value to zero:
– Torque is calibrated
Check the connection between the PC and
the stirrer
(The stirrer is switched off after 60
seconds without command input)
Identify device:
–
Display of the tripped device
begins to flash
Display temperature
Display the set rotation period and remai-
ning time
72