Heidolph Hei-TORQUE Expert Serie Notice D'instructions page 61

Operation
Hei-TORQUE Ultimate 400
➜
Stop the rotational movement.
➜
To switch between gear stage I and II, press the [
control panel:
➜
The set gear stage is shown on the display.
When working through a profile/favorite the gear stage is selected
automatically.
Starting/stopping rotation
WARNING
Risk of injury due to glass break and leaking medium
• Select the diameter of the laboratory vessel so that the stirrer tool turns
• After clamping the stirrer tool and before the process starts, check the
• Never start up stirring tools or chucks that have an unbalance, and
Risk of injury on rotating parts
• Never grip turning parts.
• Always wear close-fitting clothing when working with the device.
• Do not wear any accessories such as ties, scarves, shawls, pieces of
• When working with the device, tie back long hair or wear a cap or hair
Property damage, loss of production
• Adjust the start-up behavior of the device to the specific properties of
• Follow the specific safety instructions for the substances to be
• Always wear the required individual personal protective equipment
Start and stop the rotational movement at the switched on device using the [
off
] swipe field (see also section „Stirrer on/off swipe field" on page 52):
inside the vessel without touching it.
stirrer tool and the chuck for smooth running.
replace them immediately.
jewelry, etc. when working with the device.
net.
the sample to be processed to avoid overflowing/ejection of the sample
or overloading of the stirrer tool (safety settings!).
processed (refer to the safety data sheets if applicable).
(PPE).
Stage II
] function button on the
61
Stirrer on/