Heidolph Hei-TORQUE Expert Serie Notice D'instructions page 59

Commissioning
Hei-TORQUE Expert restart function
➜
Switch on the device and use the speed controller to set the rotational speed value to
213 rpm
[ ]: Value has white background field.
➜
Wait for approx. six (6) seconds until the value is accepted: Value is displayed without
background field.
➜
Then use the speed controller to set the rotational speed values in chronological order to
214 rpm 215 rpm
[ ], [
is accepted.
➜
As soon as the last value [
–
On activating the function, the [
– In operation with active automatic restart, a white warning symbol is shown at the top
edge of the screen.
–
On deactivating the function, the [
–
As soon as the automatic restart function is deactivated, the warning symbol at the
top edge of the screen goes out.
On restarting an Hei-TORQUE Expert after a power interruption, a
Rotation
[
warning symbol at the top edge of the screen then flashes until the rota-
tional movement is stopped normally.
A power interruption that occurs during unsupervised operation can be
identified by the flashing function.
Hei-TORQUE Ultimate restart function
➜
Switch on the device and, if applicable, use the push-and-rotary control to select the
Speed
[ ] parameter on the device display (value is displayed in orange font). Press the
push-and-rotary control to confirm.
➜
Use the push-and-rotary control to set the rotational speed value to [
briefly until the value is accepted (value is displayed continuously).
➜
To activate/deactivate the function, press and hold the push-and-rotary control and then
Cal
press the [ ] function button.
–
On activating the function, a white separating line appears between the header and
the central area.
– On deactivating the function, the white separating line between the header and the
central area is hidden.
On restarting an Hei-TORQUE Ultimate after a power interruption, a
Rotation
[
ting line between the header and the central display area then flashes red
until the rotational movement is stopped normally.
A power interruption that occurs during unsupervised operation can be
identified by the flashing function.
216 rpm 217 rpm
], [ ] and [
217 rpm
] has been accepted, the status change is completed:
restart on
restart off
] warning triangle appears on the display briefly, a white
] warning triangle appears on the display briefly, the separa-
59
] and wait each time until the value
] notice is displayed briefly.
] notice is displayed briefly.
213 rpm
] and wait