Publicité
Les langues disponibles
Les langues disponibles
Commissioning
Commissioning
Mounting the support rod
The supplied support rod is used to fit the stirrer on a stand or a wall grid.
Insert the support rod in the receiving hole at the back of the stirrer so that the screwed-in grub
screw presses on the flat area of the support rod and thus fixes it securely:
➜
Turn the grub screw clockwise to fix the support rod.
Tighten the grub screw by hand only and with the help of the hex wrench
supplied.
Make sure that you do not overtighten the grub screw, as this damages
the thread.
➜
Turn the grub screw counterclockwise to loosen and dismantle the support rod.
➜
Then fix the fitted support rod to an adequately load-bearing wall grid or a stand with the
help of suitable clamps (for suitable accessories, see www.heidolph.com).
53
Publicité
