Publicité
Les langues disponibles
Les langues disponibles
Operation
Saving another profile with the same gear stage:
Back
➜
Press the
button to switch back to the higher-level menu to create further profiles
with the same gear stage.
–
The last stored profile is offered as a template by default.
–
Adjust the existing values as required and save the profile as described above.
Home
➜
Then press the
Saving another profile with a different gear stage:
To create other profiles with a different gear stage, proceed as follows:
➜
Follow the instructions to create a profile up to the input of the profile designation (see
previous section).
➜
After confirming the profile designation, if the last stored profile is offered as a template,
Delete
confirm with
–
With this selection, all the template's ramp data are deleted.
Home
➜
Use the
button to switch back to the Device menu.
➜
Determine the required gear stage, see section „Selecting the gear stage" on page 60.
Edit profile
➜
Open the
➜
Create a new profile with changed gear stage.
Favorites
Hei-TORQUE Ultimate type devices provide the option of storing multiple consecutive process
steps (ramps) as a profile in the system memory (see section „Profiles" on page 66).
The stored profiles can be displayed and started, adjusted and deleted from the system via the
Favorites
menu.
Favorites
➜
Open the
–
All stored profiles are listed on the display.
➜
Select the required profile and press the push-and-rotary control to confirm.
Options
Display
➜
Select
, to display all the profile's data.
➜
To start the profile, select the
bottom edge of the display and then press the push-and-rotary control to confirm.
Activate
–
If
Continuous operation
–
If
continuous loop until the stirring movement is stopped manually
Edit
➜
Select
to open the profile and use it as a template for a new profile. After calling up
the profile, follow the instructions in section „Creating a profile" on page 66.
Delete
➜
Select
to remove the profile from the system memory.
button to switch back to the Device menu.
.
submenu.
menu from the Device menu:
Activate
is selected the profile is worked through once and then the stirrer stops
is selected the profile is worked through in a
Continuous operation
or
67
at the
Publicité
