Display Settings - Torqeedo Travel 603 Mode D'emploi Abrégé

Start-up
5.2 Start-up of the on-board computer
5.2.1 Displays and symbols
The tiller is fitted with an integrated display or onboard computer and three buttons.
1
2
3
4
Fig. 10: Overview of multifunction display / Multifunction display – Set-up menu
1
Battery charge state in percent
2
Remaining range at current speed
3 Speed over ground
4 Present power consumption in Watts 9
5
Drive slowly
V. 1.0 / English
5
6
7
8
9
6
Charging
7
GPS searching
8 Stop
Temperature
10 Error
Drive Displayed when the battery capacity is <30 %. Three beeps will
slowly (5) sound. The beep will sound again once the state of charge drops
below 20 % and 10 %.
Charging (6) Displayed during charging.
GPS The integrated GPS module searches for satellite signals in order to
searching (7) calculate speed.
Stop (8) This symbol appears if the tiller handle needs to be placed in the
neutral position. This is necessary before you can move off.
Temperature
This symbol appears in case of excess temperature of the motor
(9) or battery. In this case, the motor itself reduces the power
independently.
Error (10) In the event of an error, the Error symbol appears in the bottom
box, and an error code is displayed. The code indicates the
component which triggered it, and also the component error.
Details of the error codes are found in Chapter 9, "Error
messages".
5.2.2

Display settings

10
In the Set-up menu, you can select the units to be displayed on-screen (in orange).
1. Press the Set-up button in order to access the Set-up menu.
2. Use the CAL button to set the unit in which the remaining range is to be
displayed.
3. Use the CAL button to change the unit, and confirm this using Set-up.
✓ The second unit can now be changed.
✓ Repeatedly pressing the SET-UP button will open the main screen.
page 23 / 140