OEG KSF-Pro Mode D'emploi page 41

SERVICE PARAMETERS
Service parameters are divided into the following groups: S1 - general settings, S2 - set-
tings for the first heating circuit, S3 - settings for the second heating circuit, S4 - settings
for domestic hot water, S5 - settings for boilers in S6 - settings for alternative energy
sources.
Service parameters enable you to choose among various additional functions and adapta-
tions of controller's operation. When you select the requested parameter group, a new
screen appears:
Parameter mark.
Factory set value of
the parameter.
Parameter
description.
You can change the setting by pressing the
fault. A new screen appears for the entry of unlocking code:
The factory set code is 0001.
You can change the parameter value with buttons
pressing the button. Now you can move on to another parameter with buttons
, and repeat the procedure.
Exit parameter settings by pressing the
Only a trained professional shall perform the changing of service and func-
tion parameters.
- Parameter is locked.
HYDRAULIC SCHEME
Use buttons
change and press the
When the number begins to flash, you can change it with
buttons and
button. When the correct code is entered, the controller
will unlock the parameters and return to the menu with the
selected group of parameters.
Exit the unlocking code entry by pressing the
ton.
button.
41
Parameter value.
Settings range.
button. Parameters are locked by de-
and to find the number you wish to
button.
, and confirm it by pressing the
and . Confirm the selection by
but-
and
Service setting manual