OEG KSF-Pro Mode D'emploi page 35

CoNTRoLLER PARAMETERS
All additional settings and adaptations of the controller's operations are performed with the
help of parameters. Available are user, service and function parameters. Located are on
the second menu screen.
In each group, only the parameters used in the selected hydraulic scheme
can be seen. Factory set values of parameter settings also depend on the
selected hydraulic scheme.
USER PARAMETERS
User parameters are divided into the following groups: P1 - general settings, P2 - settings
for the first heating circuit, P3 - settings for the second heating circuit, P4 - settings for do-
mestic hot water, P5 - settings for boilers, and P6 - settings for alternative energy sources.
When you select the requested group of parameters in the menu, a new screen appears:
Parameter mark.
Graphic display
of the setting.
Parameter
description.
You can change the settings by pressing the
to flash. Now you can change it with buttons
the button. Now you can move on to another parameter with buttons
repeat the procedure.
Exit the parameter settings by pressing the
SERVICE SETTINGS MANUAL
AUT. SWITCHOVER SUMMER /
WINTER
0- NO
1- YES
Current parameter value.
Last confirmed setting value.
Factory set value.
Setting range.
Current parameter value.
button. The setting value will begin
and . Confirm the setting by pressing
button.
35
and , and
Service setting manual