Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
Installation Instructions
DE
EN
Basic Wall Mount
FR
Selecting Installation Location
IT
DANGER
ES
Improper use of the charger or non-compliance with
PT
the safety instructions may result in short circuits,
electric shocks, explosions, fires or burns.
NL
e Do not install the basic wall mount in potentially
explosive atmospheres.
SV
e To reduce the risk of explosion – particularly in
FI
garages – make sure that the control unit is
located at least 50 cm above the floor during
DA
charging.
e Observe the locally applicable electrical
NO
installation regulations, fire protection measures,
EL
accident prevention regulations and escape
routes.
CZ
The basic wall mount is designed for indoor and
HU
outdoor installations.
The following criteria must be considered when
PL
selecting a suitable installation location:
HR
– Install the electrical socket and basic wall mount
preferably in a covered area protected against
SK
direct sunlight and rain (e.g. in a garage).
– Do not spray the basic wall mount directly with
SL
water (e.g. high-pressure cleaning equipment or
ET
garden hoses).
– Do not install the basic wall mount under
LT
suspended or hanging objects.
– Do not install the basic wall mount in stables,
LV
livestock buildings or locations where ammonia
RO
gases occur.
– Install the basic wall mount on a smooth surface.
BG
36
– In order to ensure secure fastening, check the
condition of the wall before installing.
– Install the basic wall mount so that it is not near
pathways and the charging cables do not cross
any pathways.
– Install the basic wall mount so that the distance
between the plug and the socket does not exceed
Electric shock, fire
the length of the available supply cable.
– Install the electrical socket as close as possible to
the preferred vehicle parking position. Take the
orientation of the vehicle into account.
– The distance of the electrical socket from the
floor and ceiling should be selected in compliance
with national regulations and standards so that
comfortable use is ensured.
f Refer to chapter "Safety Instructions" on
page 23.
Tools Required
– Spirit level
– Power or hammer drill
– Screwdriver
Installing Basic Wall Mount
Fig. 8: Drilling dimensions
1. Mark the drill holes on the wall.
2. Drill the mounting holes and insert wall plugs.
3. Press wall mount 2 from the front into the
cable route 1.
4. Screw the wall mount onto the wall.
Publicité
