Stryker IsoAir 2941 Manuel D'utilisation page 32

S S t t a a r r t t i i n n g g o o r r s s t t o o p p p p i i n n g g t t h h e e A A S S T T m m o o d d e e
The AST mode is on by default. The AST mode automatically adjusts air cell pressures to control patient immersion. The
AST mode can be on when static mode or ALP mode is on. You can start or stop the AST mode from either the home
screen or the mode screen.
1. To start the AST mode, press the A A c c t t i i o o n n button next to the A A S S T T m m o o d d e e icon (Figure 34).
2. To stop the AST mode, press the A A c c t t i i o o n n button next to the A A S S T T m m o o d d e e icon (Figure 35).
T T u u r r n n i i n n g g t t h h e e L L A A L L o o n n o o r r o o f f f f
LAL is on by default. You can turn LAL on or off from either the home screen or the mode screen.
1. To turn on LAL, press the A A c c t t i i o o n n button next to the L L A A L L o o f f f f icon (Figure 36).
2. To turn off LAL, press the A A c c t t i i o o n n button next to the L L A A L L o o n n icon (Figure 37).
EN 28
F F i i g g u u r r e e 3 3 4 4 – – A A S S T T m m o o d d e e o o f f f f
F F i i g g u u r r e e 3 3 5 5 – – A A S S T T m m o o d d e e o o n n
F F i i g g u u r r e e 3 3 6 6 – – L L A A L L o o f f f f
2941-009-001 Rev AA.0