Stryker IsoAir 2941 Manuel D'utilisation page 27

1. Press and wait for M M a a x x I I n n f f l l a a t t e e to fully inflate. See Starting or canceling Max Inflate (page 23).
2. Position one patient support platform alongside the other patient support platform while minimizing the gap between the
two platforms.
3. Set the brakes to O O N N for both patient support platforms.
4. Adjust the patient support platform heights so that they are level with one another.
5. Transfer the patient following all applicable safety rules and institution protocols for patient and operator safety.
C C a a r r d d i i o o p p u u l l m m o o n n a a r r y y r r e e s s u u s s c c i i t t a a t t i i o o n n ( ( C C P P R R ) )
CPR compressions may begin as soon as you remove the CPR connector.
N N o o t t e e - - It is recommended that you remove the CPR connector. Follow your hospital protocols to complete CPR.
1. Depress the tabs on both sides of the CPR connector. Pull straight out to disconnect the CPR from the pump (Figure
21).
2. Remove the AST cable to prevent damage to the cable (recommended).
S S t t a a r r t t i i n n g g o o r r c c a a n n c c e e l l i i n n g g M M a a x x I I n n f f l l a a t t e e
To start or cancel Max Inflate:
1. On the home screen, press the A A c c t t i i o o n n button next to the M M o o d d e e icon (Figure 22).
2. To start maximum inflation, press the A A c c t t i i o o n n button next to the M M a a x x I I n n f f l l a a t t e e icon (Figure 23).
2941-009-001 Rev AA.0
F F i i g g u u r r e e 2 2 1 1 – – C C P P R R c c o o n n n n e e c c t t o o r r
F F i i g g u u r r e e 2 2 2 2 – – H H o o m m e e s s c c r r e e e e n n
23 EN