Sygonix 1559246 Notice D'emploi page 91

Set output #1 or #2 to toggle mode:
When a valid user code is entered, the corresponding output stays activated until a user code is
entered again. Use this mode to control (arm/disarm) an alarm system.
Proceed as follows:
• The combination lock must be in programming mode (see section 12. a) for details).
• Enter the programming code for output #1 or #2:
Setting output #1 to toggle mode
Setting output #2 to toggle mode
• Press the button to confirm your entry. The combination lock will beep twice and the mid-
dle LED will flash two times to indicate that the setting has been saved.
Example 1: Set output #1 to toggle mode
(a) (b)
(a) Set output #1 to toggle mode
(b) Saves the setting (the lock will beep twice and the middle LED will flash two times)
Example 2: Set output #2 to toggle mode
(a) (b)
(a) Set output #2 to toggle mode
(b) Saves the setting (the lock will beep twice and the middle LED will flash two times)
91