Sygonix 1559246 Notice D'emploi page 90

Activating output #1 or #2 for a limited period:
When you enter a valid user code (or visitor code), the corresponding output will remain acti-
vated for the preset duration. The output will be disabled when the set time has elapsed. Use this
mode if you want the door opener to keep the door open for a few seconds.
Proceed as follows:
• The combination lock must be in programming mode (see section 12. a) for details).
• Enter the programming code for output #1 or #2:
Activate output #1 for a limited period
Activate output #2 for a limited period
• Enter the duration (in secs) for which output #1/#2 should remain activated:
.....
• Press the button to confirm your entry. The combination lock will beep twice and the mid-
dle LED will flash two times to indicate that the time has been saved.
Example 1: Activate output #1 for 10 seconds
(a) (b)
(a) Programming code for output #1
(b) Duration "10" = Activates the output for 10 seconds when a valid user code (or visitor code)
is entered
(c) Saves the setting (the lock will beep twice and the middle LED will flash two times)
Example 2: Activate output #2 for 7 seconds
(a) (b) (c)
(a) Programming code for output #2
(b) Duration "7" = Activates the output for 7 seconds when a valid user code (or visitor code) is
entered
(c) Saves the setting (the lock will beep twice and the middle LED will flash two times)
90
Activation duration in seconds (1.....999)
(c)