GYS ARCPULL 200 Manuel D'utilisation page 29

Operating manual
2. POWER SUPPLY AND POWER UP
• This product is fitted with a 16 A CEE7/7 socket which must be connected to a single-phase power supply with a earthed neutral
between 110 VAC and 240 VAC (50 - 60 Hz). The absorbed current (I1eff) is indicated on the device, for its maximum setting.
Check that the power supply and its protection (fuse and/or circuit breaker) are compatible with the current required during use.
This equipment is designed to operate on an electrical installation equipped with a 16A curve C, D or K circuit breaker.
In some countries, changing the plug may be necessary to ensure the machine's optimum performance. The user has to make sure
that the socket is accessible.
• Switching on is done by positioning the ON/OFF switch to «|».
• The device will activate protection mode if the power supply voltage is over 265 V AC. If this is the case,
the machine displays POWER DEFAULT. Normal functioning will resume once the power supply is under
265V.
2.1. WORKING OFF A GENERATOR
This equipment can operate with single-phase generators provided they meet the following requirements:
- The voltage must be AC, regulated as specified (110-240 Vac) and with a peak voltage of less than 400 V,
- The frequency must be between 50 and 60 Hz.
- The power must be at least 7kVA.
It is imperative to check these conditions, as many generators produce high voltage spikes that can damage equipment.
2.2. USE OF EXTENSION LEAD
This equipment can be connected to the electrical installation with an extension lead as long as it matches the following require-
ments:
– Single-phase extension lead with earth conductor.
- The length must not exceed 10m
- The cable cross-section must not be less than 2.5 mm².
2.3. CONNECTING THE GUN TO THE POWER SOURCE
The connection and disconnection of the gun control connector to the
power source socket must only be done with the power source switched
off.
The ring of the gun control connector must always be properly screwed
to the power source socket before starting the product.
It is possible to connect an ArcPull 700 gun to this power source. In this case, use texas adapters 25 mm² -> 50 mm² (2 x 038127)
to connect the gun connector to the power source sockets.
2.4. PRODUCT UPDATE
The product has a USB connector on the front panel protected by a cap, to update the
software (adding synergies, new features). Contact your reseller for more details.
3. PROCESS FOR WELDING AN INSERT WITH DRAWN ARC
The drawn arc is used to weld inserts (draw ring, studs, studs, etc.) on a workpiece by bringing the two parts together in an electric
arc and making contact between them.
Reminder of the principles of drawn arc welding (for more details, refer to ISO 14555):
There are 4 main stages: ignition, penetration and cleaning, the arc, and the binding
Translation of the original
instructions
ARCPULL 200
29