GYS ARCPULL 200 Manuel D'utilisation page 39

Operating manual
7.3. LIST OF PROMPTS SHOWN AT THE BOTTOM OF THE DISPLAY
Message
Gun disconnected
Texas disconnected
Texas inverted
Ready
Movement only
Contact
Welding
Welding completed
Pre-Gas
Lost contact
Arc breakage
Lift gun
7.4. MAIN MENU
To access the Main Menu from Synergic and Manual modes, press the Menu/Enter button
Press the G+ and G- keys to move the section cursor. Make the selection by pressing the Menu/Validate button.
• «Settings» accesses the welding parameters (synergic or manual).
• «Manual Mode»/» Synergic Mode» changes the welding method of the machine
• «Configuration» accesses the advanced configuration of the machine (languages, gas management, information, etc.).
Press the back button to return to the welding screen.
Translation of the original
instructions
Main Menu
> Settings
Manual Mode
Configuration
Description
No gun is connected to the unit.
The positive texas of the gun is not connected to the power
source (no. 6 in figure 2).
(Synergic mode only) The polarity of the texas connectors is
reversed in relation to the polarity required by the selected
synergy.
The rest period is complete the unit is now available to weld.
A trigger pull was detected without an insert being brought into
contact with the support plate. The gun is effectively a mechani-
cal movement only, the power source is not switched on.
The product detects that an insert is in contact with the support
plate. If welding is done with gas shielding, the solenoid valve
opens for pre-gas.
Welding cycle in progress
The welding cycle is complete
Displayed when a trigger pull is detected before the pre-gas
time has elapsed (see section 7.4.3). For the welding to take
place, it is necessary to remain in the right position (insert is
always in contact with the support sheet), and wait for the end
of the pre-gas.
Displayed when contact between the insert and the support
sheet is lost before the pre-gas time has elapsed.
An arc break occurred during the welding cycle.
Checking the weld will be necessary.
Displayed at the end of the welding cycle, if the gun is still in
position on the insert.
.
ARCPULL 200
39