GYS ARCPULL 200 Manuel D'utilisation page 34

Operating manual
5.2. ADJUSTING A STUD HOLDER/INSULATION NAIL HOLDER
Adjustment screw
1) Unscrew the locking nut on the stud holder adjusting spindle.
2) Insert the attachment into the stud holder and adjust the screw so that the end of the attachment protrudes 5 mm from it..
3) Screw on the locking nut.
Note: If the weld of the insert shows marks of the stud holder at the
weld, adjust the stud holder screw so that the insert extends a
little further
from the stud holder.
Note : In the case of insulation nail application, no adjustment is necessary. Insert the insulation nail into the holder as far as it will
go.
5.3. USING THE PULL RING ATTACHMENT (059610)
Slightly unscrew the knurled nut (no. 2 - Fig 2) from the
gun shaft.
Position the ring holder until it stops and then tighten the
knurled nut.
Position the pull ring in the ring holder until it stops.
34
Translation of the original
instructions
Lock-
nut
Markings
ARCPULL 200
5 mm