GYS ARCPULL 200 Manuel D'utilisation page 43

Operating manual
8. ERROR MESSAGE, DEFECTS, CAUSES SOLUTIONS
This device has a fault monitoring system. In the event of a fault, error messages may be displayed.
Error message
OVERHEATING DEFECT
SECTOR DEFECT
PRESSED KEY
COM. DEFECT
OVERHEATING DEFECT
MOTOR DEFECT
WARRANTY CONDITIONS
The warranty covers any defects or manufacturing faults for two years, from the date of purchase (parts and labour).
The warranty does not cover:
• Any other damage caused during transport.
• The general wear and tear of parts (i.e: electrode holder, earth return rods, etc.).
• Incidents caused by misuse (incorrect power supply, dropping, disassembly).
• Faults due to the environment (pollution, rust, dust).
In the event of a fault, please return the appliance to your distributor, along with:
- a dated proof of purchase (receipt, invoice...)
a note explaining the malfunction.
Translation of the original
instructions
Meaning
Thermal protection of the
power source.
Mains voltage default.
Keypad fault.
Communication fault with
the gun.
Gun thermal protection.
Wired temperature sen-
sor fault.
Causes
Maximum duty cycle
reached.
Mains power is out of range
or one phase is missing.
A key on the keypad is
pushed when the machine is
switched on.
Communication between the
gun and the power source is
not working.
Maximum duty cycle
reached.
The temperature sensor is
disconnected.
ARCPULL 200
Solutions
Wait for the indicator to turn off
before resuming welding opera-
tions.
Have your electrical installation
checked by a qualified person.
Reminder: the unit is designed to
operate on a single-phase 110-
240 Vac 50/60 Hz mains supply
Ask a qualified person to check
the keypad.
Reconnect the gun and switch
the machine back on.
If the problem remains, have
the product checked by qualified
personnel.
Wait for the indicator to turn off
before resuming welding opera-
tions.
Ask a qualified person to check
the keypad.
43