GYS ARCPULL 200 Manuel D'utilisation page 36

Operating manual
6. HANDLING THE GUN
6.1. WELDING PULL RINGS
1. Mount the ring holder (see §5.3).
2. Strip off all paint from the area where the weld is to be executed.
3. Select the correct synergy to suit the welding of the ring.
4. Connect the negative texas plug from the gun to the unit (no earth
clamp is used).
5. In the case of manual operation; set the digital spring «Flex» to OFF
(see §7.4.2).
6. Insert a ring into the ring holder.
7. Unlock the ground rods with the knob.
8. Position the gun on the workpiece and bring the ring into contact with
it. As soon as the gun makes a «beep» or that the LED contact (blue) is
switched on, lock the ground rods with the knob.
9. Press the trigger
10. Once the weld is complete, unlock the knob to release the rods and
lift the gun to remove
the ring
Every 30 pull ring welds, the message «Check stems» appears on the dis-
play. Check the end of the ground rods (no. 4 figure 2). If they show signs of
welding, lightly sand them with abrasive paper to
restore their electrical contact.
Press to confirm and reset the counter.
To deactivate this function, see ( §7.4.3.1 )
Note : This function is not possible when an ArcPull 700 gun is used (see §2.3)
6.2. WELDING OF ACCESSORIES EXCLUDING PULL RINGS
1. Mount and adjust the accessory (gas shield, ceramic adapter, rivet extraction attach-
ment)
2. Position the ground clamps on the support sheet so that it is equidistant between
each clamp and the area where the insert is to be welded (see section 4.5). The groun-
ding areas should be stripped, cleaned and free of grease.
3. Select the appropriate synergy, or, in the case of manual operation: turn ON the digi-
tal «Flex» spring (see §7.4.2).
4. Place the gun on the sheet. As soon as the gun makes a «beep» or that the LED
contact (blue) is switched on, press the gun so that the attachment is properly pushed
onto the sheet (there must be no tilting movement).
5.
6. Once the weld is complete, lift the gun to release
the insert.
36
Translation of the original
instructions
Squeeze the trigger while holding the gun firmly
against the support plate.
ARCPULL 200