GYS ARCPULL 200 Manuel D'utilisation page 33

Operating manual
5. INSTALLATION OF ACCESSORIES AND GUN ADJUSTMENT
The fitting of accessories and the adjustment on the gun must be done while:
- the gun is connected to the power source
- the product is turned on
- the gun initializing phase is completed (trigger pull command)
5.1. REPLACEMENT AND LENGTH ADJUSTMENT OF THE GROUND RODS (059627)
Note : Replacement of the ground rods is necessary if they have excessive markings on the tips, or if they have been bent as a
result of the gun being dropped.
Loosen the locking knob (no. 3 in Figure 2) so that the
ground rods (no.4 in Figure 2) are extended as far as
possible from the gun.
Then tighten the locking knob.
Unscrew the two cover screws and release the cover
towards the front of the gun.
Slightly unscrew the two screws used to hold the rods.
If replacing the rod, remove the rods by pulling on them,
then put a new one in.
Adjust the length of the gun rods to achieve a
dimension L = 120mm (dimension between the end of the
gun and the edge of the flanges).
Tighten the two rod clamping screws.
Replace the cover on the front of the gun and tighten the
two retaining screws.
Translation of the original
instructions
L
ARCPULL 200
Press trigger
33