Publicité
Les langues disponibles
Les langues disponibles
The power button will light up green when aView is turned ON and not connected to mains
and orange when aView is connected to mains. When aView is turned off, fully charged and
connected to mains the button will turn green.
If the battery is critically low, the recording functions will become unavailable.
If the aView is turned off and the battery is critically low, the power button will flash orange
five times every ten seconds to remind that charging is needed.
5.
Connect the selected Ambu visualization device to aView by plugging the cable connector
into the corresponding female connector on aView (push aside the rubber cover)
5a or 5b . Align the arrows on the visualisation device and aView before insertion.
6.
Verify that a live video image appears on the screen. Point the distal end of the Ambu
visualization device towards an object, e.g. the palm of your hand 6 .
7.
Adjust the image preferences on aView if necessary – refer to the online aView User
Guide on www.ambu.com.
4.2. Installing, Preparing and Operating the Ambu Visualization Device
Please refer to the Instruction for Use for the specific visualization device.
4.3. Operating the aView Monitor
Startup Image Mode
Starts immediately after the power
button is pressed and continues
until the User Interface is loaded
(after approximately 1 min).
A live image from the plugged in Ambu
visualization device is available while aView
is loading. If no device is connected the
screen will be blue.
The screen layout may vary depending on
the software version.
Interface nomenclature
Power button
Brightness adjustment
Contrast adjustment
Snap shot
User Interface
A live image is available and the User
Interface displays advanced user functions
(refer to the online aView User Guide on
www.ambu.com).
aView starts up in the Blue tab for Live Image
Viewing and recording live image.
The screen layout may vary depending on
the software version.
Video recording
Viewing and recording
live image
Managing saved files
System settings and
User Accounts
9
Publicité
