Continuous Operation Duomax 1030, Polymax 1040; Timer Mode Duomax 1030, Polymax 1040 - Heidolph Hei-MIX Unimax 1010 Mode D'emploi

Operation

Continuous operation Duomax 1030, Polymax 1040

In continuous operation, the shaking movement can be started and stopped manually
as required after switching on the device.
➜
Place the vessel(s) on the platform. Observe the instructions in section
"Attachments" on page 41.
➜ Ensure that the speed control is set to zero.
➜
Switch on the device (see "Switch the device on/off" on page 42).
➜ Start shaking operation by increasing the intensity up to the desired value, using
the speed control.
➜
Stop the shaking movement by turning the speed control back to zero.
The shaking intensity (speed) can be adjusted at any time during
operation.

Timer mode Duomax 1030, Polymax 1040

In timer operation, a specific period of time can be set for continuous shaking.
➜ Place the vessel(s) on the platform. Observe the instructions in section
"Attachments" on page 41.
➜
Switch the device to time mode, using the time/speed selection switch:
Time control
➜ Use the
➜ Switch on the device (see "Switch the device on/off" on page 42)..
➜
Start shaking operation by increasing the intensity up to the desired value, using
the speed control.
The shaking movement stops automatically as soon as the timer
has expired.
The shaking movement can be stopped manually at any time by
resetting the speed control to zero.
to set the desired operating time.
46