Attachments - Heidolph Hei-MIX Unimax 1010 Mode D'emploi

Commissioning
Connect the power supply cord
➜
Before connecting the power supply cord, make sure that the main switch of the
device is in position 0 (off).
➜ Connect the cable coupling of the supplied coded power supply cord (see figure) to
the IEC appliance inlet on the back of the device:
➜
Connect the power supply cord to a properly secured mains socket-outlet.
Disconnect the power supply cord
➜
Before disconnecting the mains connection cord, switch off the device.
➜
Disconnect the mains connection cord from the mains socket-outlet.
➜ Disconnect the power supply cord from the IEC appliance inlet on the back of the
device.

Attachments

Use the various optional attachments to fix your laboratory vessels. When mounting the
attachment on the shaking platform of the device, refer to the mounting instructions
delivered with each attachment.
At low shaking frequencies, vessels such as Petri dishes can also be
placed directly on the non-slip contoured rubber mat.
➜
➜
Always place individual vessels in the center of the shaking
platform.
Always distribute several vessels evenly on the shaking
platform.
41