Control And Operation; On/Off Switch And Setting Speed; Shaking With Tilt Operation; Shaking With Continuous Operation - Heidolph REAX top Mode D'emploi

E
B. CONTROL AND OPERATION
B. CONTROL AND OPERATION

4. ON/OFF switch and setting speed

(Figures 1, 2)
– The appliance is switched on at the
ON/OFF switch (1). The green control lamp
in the ON/OFF switch (1) indicates that the
appliance is ready for operation.
– The speed (shaking intensity) is selected
using the speed setting knob (2). It can be
increased by turning this knob to the right.
– The REAX top has a dial (5) and the REAX
control a scale (5) with precision speed
display in 1/min.

5. Shaking with tilt operation

(Figures 1, 2, 8)
– Before starting the shaker, select a
low speed to prevent splashing
when the appliance starts up.
– The operating mode is selected with the
slide switch (6). To select tilt operation, turn
the slide switch to the right as far as it will
go. The symbol
switch (6) indicates the operating mode.
– Shaking is actuated by the pressure of the
test tube on the tray and stops again auto-
matically as soon as the test tube is removed.
6. Shaking in continuous operation
(Figures 1, 2, 7)
– Before starting the shaker, select a
low speed to prevent splashing
when the appliance starts up.
– The operating mode is selected with the
slide switch (6). To select continuous op-
eration, turn the slide switch to the left as
far as it will go. The symbol
right of the slide switch (6) indicates the
operating mode.
– In this position, the tray are shaken conti-
nuously.
16
(7) to the left of the slide
(8) to the
ROUTINE CLEANING AND
ROUTINE CLEANING AND
MAINTENANCE
MAINTENANCE
– Use a damp cloth (mild soap solution) to
wipe clean the housing and surfaces of
the appliance.
– Important: Never use chlorine bleach or
chlorine-based detergents, scouring
agents, ammonia, cleaning wool or clea-
ning agents with metallic components to
clean the appliance, as these would dama-
ge the surfaces of the appliance.
– The appliance is maintenance-free. Any
repairs which may be necessary must be
carried out by an authorized Heidolph
technician. Please contact your local
Heidolph dealer or Heidolph representative
(see page 19).
– To ensure the feet adhere securely
to the table top, clean the feet at
regular intervals using a damp cloth
and ethanol.